Garage Door Problem: How to Replace the Wall Switch to a Garage Door Opener?

The wall surface button that manages your garage door opener will certainly stop working over time. Due to the fact that of the selection of choices, it is a great concept to buy a wall surface button comparable to the present one. Visit http://hartfordgaragedoorrepair.com/ to hire a professional for your garage door repair needs.

Materials You’ll Need to Repair
#. Stepladder
#. Phillips-head screwdriver
#. Little flat-head screwdriver
#. Cable pole dancers.

Location a stepladder under the garage door opener electric motor head to ensure that you can get to the opener power cable. Disconnect the opener power cable from the ceiling electric outlet.

Eliminate both screws that protect the wall surface button to the wall surface with a Phillips-head screwdriver. Some versions have a trim cover to conceal the screw heads. Place a little flat-head screwdriver in between the wall surface as well as the cover control to tear the cover off.

Draw the wall surface change far from the wall surface as well as transform the change to access the back. Loosen up both incurable screws that protect the low-voltage bell cable to the wall surface button with the Phillips-head screwdriver. Throw out the old wall surface button.

Cut the bare ends of each cord with a set of cord pole dancers. Get rid of 1/4- inch insulation from completion of each cord with the cord pole dancers as well as flex completions in a U form to fit about the brand-new wall surface button incurable screws.

Loosen up the screws on the back of the brand-new wall surface button sufficient to position the bare ends of the cable around them. The incurable screws have a wand also a b, noting where each of the ends of the bell cord affix.

An area the cord around the particular incurable screw and also safeguard the cord by tightening up the screw with the Phillips-head screwdriver. Location the wall surface turns on the wall surface and also affix the button to the wall surface with both preserving screws.

Connect the garage door opener power cable back right into the ceiling electrical outlet. Check the procedure of your brand-new wall surface button.

Tips & Warnings
Some multi-button buttons might have 3 cords attaching to the rear of the button. Mark each cable with covering up the tape with their place to help setup of the brand-new wall surface button.

Constantly detach power from garage door openers prior to making any kind of fixings.

The wall surface button that regulates your garage door opener will certainly stop working over time. Eliminate the 2 screws that safeguard the wall surface button to the wall surface with a Phillips-head screwdriver. Draw the wall surface switch over away from the wall surface as well as transform the button around to access the back. Loosen up the 2 incurable screws that safeguard the low-voltage bell cable to the wall surface button with the Phillips-head screwdriver. Loosen up the screws on the back of the brand-new wall surface button sufficient to position the bare ends of the cable around them.